Nissan Sentra Service Manual: Wiring diagram

System description

Component parts Component parts location ABS actuator and electric unit (control unit) Av control unit A/c auto amp. Ecm Ipdm e/r Tcm Data link connector EPS control unit Bc ...

Basic inspection

Diagnosis and repair workflow Interview sheet Note: Refer to LAN-16, "Trouble Diagnosis Procedure" for how to use interview sheet. ...

Other materials:

Removal and installation
A/C SWITCH ASSEMBLY Removal and Installation REMOVAL Remove the CVT shift selector finisher (CVT: RE0F11A). Refer to TM-253, "Removal and Installation". Remove the MT shift selector finisher (6MT: RS6F94R). Refer to TM-22, "Removal and Installation". Remove the A/ ...

General Precautions
Always use a 12 volt battery as power source. Do not attempt to disconnect battery cables while engine is running. Before connecting or disconnecting the ECM harness connector, turn ignition switch OFF and disconnect negative battery cable. Failure to do so may damage the ECM because ...

Installing front license plate
Use the following steps to mount the front license plate: Make holes on the plastic finisher at the location mark (small dimple) using a 0.20 in (5 mm) drill. Apply light pressure to the drill. Install the license plate holder using the two screws provided with the holder. Mount ...