Nissan Sentra manuals

Nissan Sentra Service Manual: Wind deflector

Exploded view


  1. Spring
  2. Wind deflector
  3. Roof panel
  4. Sunshade
  5. Glass lid

Removal and installation Front


Removal and installation

REMOVAL

  1. Open the glass lid.
  2. Release the springs (LH/RH), then remove the wind deflector.

INSTALLATION

Installation is in the reverse order of removal.

Sunshade
Exploded View Sunshade Moonroof unit assembly Sunshade stopper (LH/RH) Front Removal and Installation REMOVAL Remove the headlining. Refer to INT-40, "Removal and Installatio ...

Moonroof switch
Removal and installation REMOVAL Remove the map lamp. Refer to INL-52, "Removal and Installation". Release the pawls and remove the moonroof switch finisher (1). : Pawl Releas ...

Other materials:

P0139 HO2S2
DTC Logic DTC DETECTION LOGIC The heated oxygen sensor 2 has a much longer switching time between rich and lean than the air fuel ratio (A/F) sensor 1. The oxygen storage capacity of the three way catalyst 1 causes the longer switching time. To judge the malfunctions of heated oxygen sensor 2, ...

Parts Requiring Angle Tightening
Use the Tool for the final tightening of the following engine parts: Tool number : KV10112100 (BT-8653-A) Camshaft sprocket (INT) bolt Cylinder head bolts Main bearing cap bolts Connecting rod cap bolts Crankshaft pulley bolt (No the angle wrench is required as bolt flange is pr ...

Fuel gauge
NOTE: The ignition switch must be placed in the ON position for the gauge to give a reading. The gauge indicates the approximate fuel level in the tank. The gauge may move slightly during braking, turning, acceleration, or going up or down hills. The low fuel warning light comes on when ...

В© 2014-2025 Copyright www.nisentra.com