Nissan Sentra manuals

Nissan Sentra Service Manual: Preparation

Special Service Tools

The actual shape of the tools may differ from those illustrated here.

Commercial Service Tools


Commercial Service Tools

Clip list


Clip list

Descriptions for Clips

Replace any clips which are damaged during removal or installation.




Symptom diagnosis


Precaution for Work
When removing or disassembling each component, be careful not to damage or deform it. If a component may be subject to interference, be sure to protect it with a shop cloth. When removing (d ...

Symptom diagnosis
Squeak and rattle trouble diagnoses Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Workshe ...

Other materials:

Controls
Fan control dial The fan control dial turns the fan on and off, and controls fan speed. Air flow control buttons The air flow control buttons allow you to select the air flow outlets. MAX — Air flows from center and side A/Cvents with maximum cooling. — Air flows from center and side v ...

Illumination control switch signal circuit
Diagnosis procedure Regarding wiring diagram information, refer to mwi-28, "wiring diagram". 1.Check combination meter input signal Turn ignition switch on. Check voltage between the following terminals of the illumination control switch. Is the inspection result normal? ...

Coil spring
Exploded View Upper rubber seat Coil spring Lower rubber seat Rear suspension beam Front Removal and Installation REMOVAL Set a suitable jack under the rear suspension beam. CAUTION: At this step, the jack must be set only for supporting the removal procedure. For d ...

© 2014-2026 Copyright www.nisentra.com