Nissan Sentra Service Manual: Washer motor circuit
Diagnosis Procedure
Regarding Wiring Diagram information, refer to WW-24, "Wiring Diagram - With Intelligent Key" or WW-29, "Wiring Diagram - Without Intelligent Key".
1. Check front washer motor fuse
- Turn the ignition switch OFF.
- Check that the following fuse is not blown.
Is the fuse blown? YES >> Replace the blown fuse after repairing the affected circuit.
NO >> GO TO 2.
2. Check front washer motor power supply
- Disconnect front washer motor.
- Turn ignition switch on.
- Check voltage between front washer motor harness connector e8 and ground.
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair or replace the harness or connectors.
3. Check front washer motor circuit continuity
- Turn the ignition switch OFF.
- Disconnect combination switch (wiper and washer switch).
- Check continuity between combination switch (wiper and washer switch) harness connector m28 and front washer motor e8.
Is the inspection result normal? Yes >> go to 4.
No >> repair or replace the harness or connectors.
4. Check wiper and washer switch ground circuit
Check continuity between combination switch (wiper and washer switch) harness connector m28 and ground.
Is the inspection result normal? Yes >> go to 5.
No >> repair or replace the harness or connectors.
5. Check wiper and washer switch
Check wiper and washer switch. Refer to WW-45, "Component Inspection".
Is the inspection result normal? YES >> Replace front washer motor. Refer to WW-62, "Removal and Installation".
NO >> Replace wiper and washer switch. Refer to WW-63, "Removal and Installation".
Front wiper motor ground circuit
Diagnosis procedure
Regarding Wiring Diagram information, refer to WW-24, "Wiring Diagram - With
Intelligent Key" or WW-29,
"Wiring Diagram - Without Intelligent Key".
1.Check ...
Washer switch
Description
Washer switch is integrated with combination switch (wiper and washer
switch).
Combination switch (wiper and washer switch) supplies ground and fuse #
6 supplies power for the ...
Other materials:
B142X Collision detection
Description
DTC B142X COLLISION DETECTION
The air bag diagnosis sensor unit will set this DTC if it has detected a
collision which has resulted in a deployment
of one or more air bags or pre-tensioners. If this DTC is detected after a SRS
repair, the air bag diagnosis
sensor unit has not yet ...
Body sealing
Description
The following figure shows the areas which are sealed at the factory. Sealant
which has been applied to these
areas should be smooth and free from cuts or gaps. Care should be taken not to
apply an excess amount of
sealant and not to allow other unaffected parts to come into conta ...
Front seat belt
Exploded View
D-ring anchor
Seat belt height adjuster cover
Seat belt buckle
Seat belt retractor
Seat belt height adjuster
Lap belt pre-tensioner harness
connector
Shoulder belt pre-tensioner
harness connector
Front
NOTE:
LH side shown; RH side similar.
Removal an ...
