Nissan Sentra manuals

Nissan Sentra Service Manual: Unit disassembly and assembly

Nissan Sentra Service Manual / Brakes / Brake system / Unit disassembly and assembly

Rear disc brake
BRAKE PAD BRAKE PAD : Exploded View Upper sliding pin bolt Lower sliding pin bolt Bushing Cylinder body Inner shim cover Inner shim Inner pad (with pad wear sensor) Pad retaine ...

Front disc brake
Exploded View Cap Bleeder valve Cylinder body Piston seal Piston Piston boot Upper sliding pin Lower sliding pin Sliding pin boot Bushing Torque member Apply brake flui ...

Other materials:

P050A, P050B, P050E Cold start control
Description ECM controls ignition timing and engine idle speed when engine is started with pre-warming up condition. This control promotes the activation of three way catalyst by heating the catalyst and reduces emissions. DTC Logic DTC DETECTION LOGIC NOTE: If DTC P050A, P050B or P050E ...

P1652 Starter motor system comm
Description ECM controls ON/OFF state of the starter relay, according to the engine and vehicle condition. ECM transmits a control signal to IPDM E/R via BCM by CAN communication. Under normal conditions, ECM controls and maintains the starter relay in OFF state during following condition: ...

B1431, B1433 Seat belt pre-tensioner RH
Description DTC B1431, B1433 SEAT BELT PRE-TENSIONER RH The seat belt pre-tensioner RH is wired to the air bag diagnosis sensor unit. The air bag diagnosis sensor unit will monitor for opens and shorts in detected lines to the seat belt pre-tensioner RH. PART LOCATION Refer to SRC-5, " ...

В© 2014-2019 Copyright www.nisentra.com