Nissan Sentra Service Manual: Unit disassembly and assembly

Optical sensor

Removal and installation REMOVAL Remove the defroster grille (LH) using a suitable tool. Disconnect the harness connector from the optical sensor. Release the pawls and remove the optical sen ...

Front combination lamp

Exploded View Large cover (not serviceable) Small cover (not serviceable) Front combination lamp Halogen lamp bulb (high beam) Turn signal lamp bulb Turn signal lamp bulb socket LE ...

Other materials:

Front fog lamp
Aiming adjustment PREPARATION BEFORE ADJUSTING The fog lamp is a semi-sealed beam type which uses a replaceable halogen bulb. Before performing aiming adjustment procedure, check the following: Ensure all tires are inflated to correct pressure. Place vehicle and screen on level surface. ...

Power supply and ground circuit
Combination meter Combination meter : diagnosis procedure Regarding Wiring Diagram information, refer to MWI-28, "Wiring Diagram". 1.Check fuses Check that the following fuses are not blown. Is the fuse blown? YES >> Replace the blown fuse after repairing the affected circu ...

Environmental factors influence the rate of corrosion
Moisture Accumulation of sand, dirt and water on the vehicle body underside can accelerate corrosion. Wet floor coverings will not dry completely inside the vehicle and should be removed for drying to avoid floor panel corrosion. Relative humidity Corrosion will be accelerated in areas of h ...