Nissan Sentra manuals

Nissan Sentra Service Manual: Trunk lid trim

Exploded View


  1. Trunk lid finisher

Removal and Installation Front


Removal and Installation

REMOVAL

Remove trunk lid finisher clips (A) and trunk lid finisher.

INSTALLATION


INSTALLATION

Installation is in the reverse order of removal.

Trunk room trim
Exploded View Trunk floor trim Trunk front floor spacer (LH) Trunk side finisher (LH) Reflector box assembly* Trunk rear plate Trunk side finisher (RH) Trunk front floor spacer (RH ...

Instrument panel
...

Other materials:

Daytime light relay circuit
Description The bcm sends a daytime light request to the ipdm e/r via the can communication lines. The power flows through fuse 29 located in fuse block j/b to the daytime light relay coil. When the ipdm e/r operates the daytime light relay, power is sent to the daytime lamps. Diagnosis proc ...

Battery current sensor
Exploded view Battery current sensor Current sensor harness connector Removal and installation Removal Loosen the battery terminal nut and disconnect battery negative terminal. Refer to PG-50, "Exploded View". Disconnect the harness connector from current sensor. ...

B0001, B0002 Driver airbag module
Description DTC B0001, B0002 DRIVER AIRBAG MODULE The driver air bag module is dual stage and is wired to the air bag diagnosis sensor unit through the spiral cable. The air bag diagnosis sensor unit will monitor for opens and shorts in detected lines to the driver air bag module including t ...

В© 2014-2026 Copyright www.nisentra.com