Noise, vibration and harshness (NVH) troubleshooting
NVH Troubleshooting Chart
Use the chart below to find the cause of the symptom. If necessary, repair or replace these parts.

×: Applicable
Steering gear and linkageDoes not stop fully-open or fullyclosed
position
Diagnosis procedure
1. Perform initialization procedure
Perform initialization procedure.
Refer to RF-18, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair
Requirement".
Is the inspection result normal?
YES >> Inspection End.
NO >> Perform basic ins ...
Diagnosis and repair work flow
Work flow
OVERALL SEQUENCE
DETAILED FLOW
1.INTERVIEW THE CUSTOMER FOR THE SYMPTOM
Interview the customer for the symptom (the condition and the environment
when the incident/malfunction
occurs).
>> GO TO 2.
2.CHECK SYMPTOM
Check the symptom from the customer information.
> ...
System description
Component parts
Component parts location
Instrument lower finisher
Eco mode switch
The eco mode switch is installed to the instrument lower finisher.
When the ECO mode indicator lamp on the combination meter is
OFF and the ECO mode switch is pressed, the ECO mode is
active and ...