Nissan Sentra Service Manual: Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT
PRE-TENSIONER"
The supplemental restraint system such as “air bag” and “seat belt pre-tensioner”,
used along
with a front seat belt, helps to reduce the risk or severity of injury to the
driver and front passenger for certain
types of collision. Information necessary to service the system safely is
included in the sr and sb section of
this service manual.
Warning:
- To avoid rendering the srs inoperative, which could increase
the risk of personal injury or death in
the event of a collision which would result in air bag inflation, all
maintenance must be performed by
an authorized nissan/infiniti dealer.
- Improper maintenance, including incorrect removal and
installation of the srs, can lead to personal
injury caused by unintentional activation of the system. For removal of
spiral cable and air bag
module, see the sr section.
- Do not use electrical test equipment on any circuit related to
the srs unless instructed to in this
service manual. Srs wiring harnesses can be identified by yellow and/or
orange harnesses or harness
connectors.
Precautions when using power tools (air or electric) and hammers
Warning:
- When working near the airbag diagnosis sensor unit or other
airbag system sensors with the ignition
on or engine running, do not use air or electric power tools or strike near
the sensor(s) with a
hammer. Heavy vibration could activate the sensor(s) and deploy the air
bag(s), possibly causing
serious injury.
- When using air or electric power tools or hammers, always
switch the ignition off, disconnect the
battery and wait at least three minutes before performing any service.
When removing or disassembling each component, be careful not to damage
or deform it. If a component
may be subject to interference, be sure to protect it with a shop cloth.
When removing (d ...
Other materials:
System
Tire pressure monitoring system
TIRE PRESSURE MONITORING SYSTEM : System Diagram
TIRE PRESSURE MONITORING SYSTEM : System Description
The BCM has pressure judgment and trouble diagnosis functions. When the
BCM detects low inflation pressure
or another unusual symptom, the low tire pr ...
P117A AIR Fuel ratio
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC P117A is displayed with other DTC, first perform the trouble
diagnosis for the other DTC. Refer
to EC-94, "DTC Index".
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
Possible cause
...
Cooler pipe and hose
Exploded view
High-pressure service port
High-pressure pipe
Expansion valve
Low-pressure service port
Low-pressure flexible hose
Compressor
Refrigerant pressure sensor
Condenser and liquid tank assembly
High-pressure flexible hose
Low-pressure flexible hose
Low-pressure f ...
© 2014-2025 Copyright www.nisentra.com