Nissan Sentra manuals

Nissan Sentra Service Manual: Front grille

Exploded view


  1. Core support cover
  2. Front grille
  3. Emblem

Removal and installation Pawl


Removal and installati

on

REMOVAL

  1. Remove core support cover bolts (A), clips (B) and core support cover (1).


  1. Apply protective tape (A) to protect the components from damage.


  1. Remove the front grille clips (A).


  1. Release pawls from back side while pulling front grille toward vehicle front and remove front grille.

: Pawl



  1. Remove emblem from front grille (if necessary).

INSTALLATION

Installation is in the reverse order of removal.

Rear bumper
Exploded view Rear bumper side bracket (LH) Rear bumper reinforcement Rear bumper energy absorber Rear bumper fascia reflector (LH) Rear bumper fascia reflector (RH) Rear bumper fasc ...

Cowl top
Exploded view Cowl top seal Cowl top grille cap Cowl top cover Cowl top extension Cowl top extension insulator Clip EPT seal [t: 3.0 mm (0.12 in) Cowl top cover cap EPT seal [t: ...

Other materials:

Connecting procedure
NOTE: The connecting procedure must be performed when the vehicle is stationary. If the vehicle starts moving during the procedure, the procedure will be cancelled. To connect a phone to the Bluetooth® Hands- Free Phone System: Press the SETTING button. Use the TUNE/FOLDER knob to s ...

Drive belt
Automatic tensioner Generator Water pump Air conditioner compressor Crankshaft pully WARNINGBe sure the ignition switch is in the OFF or LOCK position before servicing drive belt. The engine could rotate unexpectedly. Visually inspect the belt for signs of ...

Normal operating condition
Description FUEL CUT CONTROL (AT NO LOAD AND HIGH ENGINE SPEED) If the engine speed is above 2,500 rpm under no load (for example, the selector lever position is neutral and engine speed is over 2,500 rpm) fuel will be cut off after some time. The exact time when the fuel is cut off varies b ...

© 2014-2026 Copyright www.nisentra.com