Nissan Sentra manuals

Nissan Sentra Service Manual: Engine protection control at low engine oil pressure

Nissan Sentra Service Manual / Engine / Engine control system / System / Engine protection control at low engine oil pressure

ENGINE PROTECTION CONTROL AT LOW ENGINE OIL PRESSURE : System Description

SYSTEM DIAGRAM

INPUT/OUTPUT SIGNAL CHART


INPUT/OUTPUT SIGNAL CHART

Sensor

Input signal to ECM

ECM function

Actuator

Engine oil pressure sensor Engine oil pressure Engine protection control
  • Oil pressure warning lamp signal
  • Fuel cut control
Combination meter
  • Oil pressure warning lamp
Crankshaft position sensor (POS) Engine speed
Engine oil temperature sensor Engine oil temperature

SYSTEM DESCRIPTION

*: When detecting a normal engine oil pressure, ECM turns OFF the oil


*: When detecting a normal engine oil pressure, ECM turns OFF the oil pressure warning lamp.

Intake manifold tuning system
INTAKE MANIFOLD TUNING SYSTEM : System Description SYSTEM DIAGRAM SYSTEM DESCRIPTION This system switches the length of intake air path according to the low-to-medium speed range or high spe ...

Fuel filler cap warning system
SYSTEM DIAGRAM SYSTEM DESCRIPTION The fuel filler cap warning system alerts the driver to the prevention of the fuel filler being left uncapped and malfunction occurrences after refueling, by ...

Other materials:

P062F Eeprom
DTC Logic DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition Possible causes P062F EEPROM (Internal Control Module EEPROM Error) Flash ROM error is detected when turning ON the ignition switch. TC ...

Aluminum alloy wheels
Wash the wheels regularly with a sponge dampened in a mild soap solution, especially during winter months in areas where road salt is used. If not removed, road salt can discolor the wheels. CAUTION Follow the directions below to avoid staining or discoloring the wheels: Do not use a clean ...

The door open warning continues displaying, or does not display
Description The door ajar warning is displayed even though all of the doors are closed. The door ajar warning is not displayed even though a door is ajar. Diagnosis procedure 1.Check bcm input signal Check the bcm input signal. Refer to dlk-102, "component function check" ( ...

В© 2014-2025 Copyright www.nisentra.com