Nissan Sentra Owners Manual: Hazard warning flasher switch

Nissan Sentra Owners Manual / In case of emergency / Hazard warning flasher switch

Push the switch on to warn other drivers when

Push the switch on to warn other drivers when you must stop or park under emergency conditions.

All turn signal lights flash.

WARNING

If stopping for an emergency, be sure to move the vehicle well off the road.
Do not use the hazard warning flashers while moving on the highway unless unusual circumstances force you to drive so slowly that your vehicle might become a hazard to other traffic.
Turn signals do not work when the hazard warning flasher lights are on.

The flashers will operate with the ignition switch placed in any position.

Some state laws may prohibit the use of the hazard warning flasher switch while driving.

Emergency engine shut off (Push-button ignition models only)

To shut off the engine in an emergency situation while driving, perform the following procedure: Rapidly push the push-button ignition switch 3 consecutive times in less than 1.5 seconds, or ...

Flat tire

...

Other materials:

How to erase permanent DTC
Description OUTLINE When a DTC is stored in ECM When a DTC is stored in ECM and MIL is ON, a permanent DTC is erased with MIL shutoff if the same malfunction is not detected after performing the driving pattern for MIL shutoff three times in a raw. *1: When the same malfunction is detec ...

P0127 IATSensor
DTC Logic DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possible cause P0127 IAT SENSOR-B1 (Intake air temperature too high) Rationally incorrect voltage from the sensor is sent to ECM, compared with the ...

Dtc/circuit diagnosis
U1000 can comm circuit Description Refer to lan-7, "can communication system : system description". DTC Logic Dtc detection logic Note: U1000 can be set if a module harness was disconnected and reconnected, perhaps during a repair. Confirm that there are actual can diagnostic sym ...