Nissan Sentra Service Manual: Wiring diagram

Preparation

Special Service Tool The actual shape of the tools may differ from those illustrated here. Commercial Service Tools Clip list Descriptions for Clips Replace any clips which are damaged d ...

Symptom diagnosis

Squeak and rattle trouble diagnoses Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Workshee ...

Other materials:

Changing wheels and tires
Tire rotation NISSAN recommends rotating the tires every 7,500 miles (12,000 km). See “Flat tire” in the “In case of emergency” section of this manual for tire replacing procedures. As soon as possible, tighten the wheel nuts to the specified torque with a torque wrench. Wheel ...

P0340 CMP Sensor (PHASE)
DTC Logic DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possible cause P0340 CMP SEN/CIRC-B1 (Camshaft position sensor “A” circuit bank 1) The cylinder No. signal is not sent to ECM fo ...

System
EPS system EPS SYSTEM : System Description SYSTEM DIAGRAM DESCRIPTION EPS control unit performs an arithmetical operation on data, such as steering wheel turning force (sensor signal) from the torque sensor, vehicle speed signal, etc. Then it generates an optimum assist torque ...