Nissan Sentra B18 (2020-2025) Service Manual / Electrical & Power Control / Body Control System :: Dtc/circuit Diagnosis / U2118-87 Can Comm Err (intelligent Key)

Nissan Sentra B18 (2020-2025) Service Manual: U2118-87 Can Comm Err (intelligent Key)

Dtc Description

DTC Description

DESCRIPTION

CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Sentra vehicle multiplex communication line with high data communication speed and excellent error detection ability. Modern Nissan Sentra vehicle is equipped with many electronic control unit, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN-High line, CAN-Low line) allowing a high rate of information transmission with less wiring. Each control unit transmits/receives data but selectively reads required data only. CAN Communication Signal Chart. Refer to CAN Communication Signal Chart.

DTC DETECTION LOGIC

DTC No.	CONSULT screen items (Trouble diagnosis content)	DTC Detection Condition
U2118–87	CAN comm err (Intelligent Key) [CAN communication error (Intelligent Key)]	Diagnosis condition	Ignition switch ON
		Signal (terminal)	CAN communication signal
		Threshold	Transmission error or reception error
		Diagnosis delay time	2 second or more

POSSIBLE CAUSE

CAN communication system

FAIL-SAFE

—

Dtc Confirmation Procedure

DTC Confirmation Procedure

DTC CONFIRMATION
1. CONSULT
  1. Ignition switch ON and wait for 2 seconds or more.
  2. Select “Self Diagnostic Result” mode of “BCM”.
Is DTC detected?
YES >>
Refer to DTC Diagnosis Procedure.
NO >>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO >>
Confirmation after repair: Inspection End.

Dtc Diagnosis Procedure

DTC Diagnosis Procedure

CHECK CAN COMMUNICATION
1. Check CAN communication. Refer to Trouble Diagnosis Flow Chart.
Is DTC “U2118–87” detected?
YES >>
Repair or replace the malfunctioning part.
NO >>
Inspection End.

 U0073-00 Control Module Comm Bus a Off

Dtc Description DTC Description DESCRIPTION CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Sentra vehicle multiplex ...

 U2140-87 Can Comm Err (ecm)

Dtc Description DTC Description DESCRIPTION CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Sentra vehicle multiplex ...

Other materials:

B24f4-12 Steering Heater Relay
Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis name) DTC detection condition ...

Brake Fluid
Draining Draining CAUTION: Before working, place the ignition switch in the OFF position and disconnect the harness connector from the ABS actuator and electric unit (control unit) or the negative battery terminal. Refer to Battery Disconnect ...

Trunk Lid Opener Actuator
Component Function Check Component Function Check CHECK FUNCTION CONSULT Select "Trunk/back door" in "Active Test" mode of "BCM(TRUNK)". Select “On” to check tha ...