Description
The oil pressure warning lamp stays off when the ignition switch is turned on.
Diagnosis procedure
1.Check combination meter oil pressure warning light

Is the inspection result normal? Yes >> inspection end.
No >> replace combination meter. Refer to mwi-77, "removal and installation".
The illumination control switch is inoperative
The oil pressure warning lamp does not turn offCoil spring
Exploded View
Upper rubber seat
Coil spring
Lower rubber seat
Rear suspension beam
Front
Removal and Installation
REMOVAL
Set a suitable jack under the rear suspension beam.
CAUTION:
At this step, the jack must be set only for supporting the removal
procedure. For d ...
P1586 G Sensor
DTC Logic
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
Possible causes
P1586
G Sensor
(Gravity Sensor Circuit)
When the following diagnosis conditions are
satisfied and the detection conditions are satisfi ...
Tire equipment
SUMMER tires have a tread designed to
provide superior performance on dry pavement.
However, the performance of these
tires will be substantially reduced in snowy
and icy conditions. If you operate your vehicle
on snowy or icy roads, NISSAN recommends
the use of MUD & SNOW or ALL
...