Nissan Sentra Service Manual: Symptom diagnosis

Nissan Sentra Service Manual / Body exterior, doors, roof & vehicle security / Security control system / Without intelligent key system / Symptom diagnosis

Nissan vehicle immobilizer systemnats symptoms

Symptom Table

Note:

Before performing the diagnosis in the following table, check вЂњSEC-171, "Work Flow"вЂќ.
Check that vehicle is under the condition shown in вЂњConditions of vehicleвЂќ before starting diagnosis, and check each symptom.
If the following symptoms are detected, check systems shown in the вЂњDiagnosis/service procedureвЂќ column in this order.

CONDITIONS OF VEHICLE (OPERATING CONDITIONS)

Mechanical key is not inserted into key cylinder.

Symptom	Diagnosis/service procedure	Reference page
Security indicator does not turn ON or flash.	Check vehicle security indicator	SEC-190
Security indicator does not turn ON or flash.	Check Intermittent Incident	GI-39

Dtc/circuit diagnosis

Power supply and ground circuit Diagnosis Procedure Refer to LAN-7, "CAN COMMUNICATION SYSTEM : System Description". Vehicle security indicator Description DTC DETECTION LOGIC NOTE: U ...

Removal and installation

Nats antenna amp Removal and installation REMOVAL Remove instrument finisher B. Refer to IP-14, "Exploded View". Using a suitable tool release the pawls on either side and remove the ...

Other materials:

Push-button ignition switch illumination circuit
Description Provides the power supply and the ground to control the push-button ignition switch illumination. Component function check 1.Check push-button ignition switch illumination operation Consult active test Turn the ignition switch ON. Select engine sw illumi of bcm (intelligen ...

Starting the engine
Apply the parking brake. CVT model: Move the shift lever to P (Park) or N (Neutral). P (Park) is recommended. The shift lever cannot be moved out of P (Park) and into any of the other gear positions if the ignition switch is turned to the OFF position or if the key is removed from th ...

Can communication circuit
Diagnosis procedure 1.Connector inspection Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Disconnect all the unit connectors on can communication system. Check terminals and connectors for damage, bend and loose connection. Is the inspection resu ...