Consult Function (occupant Detection)Removal and Installation
Removal and Installation
Warning:
Before servicing the SRS, place the ignition
switch in the OFF position, disconnect both battery terminals then
wait at least three minutes.
Do not use air tools or electric tools
for servi ...
Work Flow
Work Flow
CUSTOMER INTERVIEW
Interview the customer if possible, to determine
the conditions that exist when the noise occurs. Use the Diagnostic
Worksheet during the interview to document the facts and conditions
when the noise occurs and any customer's comments; refer to Diagnos ...
Disposal
Disposal
Set the
strut horizontally with the piston rod fully extended.
Drill a 2
– 3 mm (0.08 – 0.12 in) hole at the position ()
from top as shown to release gas gradually.
CAUTION:
Wear eye protection (safety glasses).
Wear ...