Factory-style information for owners and repair work

Nissan Sentra techinfo

Find Nissan Sentra owner information, maintenance instructions, technical references, service procedures and useful repair pages in one clean online library.

Nissan Sentra B18 (2020-2025) Service Manual / Engine / Engine Cooling System :: Mr20dd / Service Data and Specifications (sds). Service Data and Specifications (sds)

Nissan Sentra B18 (2020-2025) Service Manual: Service Data and Specifications (sds). Service Data and Specifications (sds)

Service Data and Specifications (sds)

Periodical Maintenance Specification

Periodical Maintenance Specification

ENGINE COOLANT CAPACITY (APPROXIMATE)

Unit: (US qt, Imp qt)

Engine coolant capacity (With reservoir tank at “MAX� level)

M/T models

6.9 (7-1/4, 6-1/8)

CVT models

7.1 (7-1/2, 6-1/4)

Reservoir tank engine coolant capacity (At “MAX� level)

0.8 (7/8, 3/4)

Radiator

Radiator

Unit: kPa (kg/cm2, psi)

Cap relief pressure

Standard

130.0 - 150.0 (1.3 - 1.5, 18.9 - 21.8)

Limit

110 (1.1, 16.0)

Leak testing pressure

157 (1.6, 22.8)

Thermostat

Thermostat

Valve opening temperature

80.5 - 83.5 °C (177 - 182 °F)

Full-open lift amount

More than 8 mm / 95 °C (0.31 in / 203 °F)

Valve closing temperature

77 °C (171 °F) or higher

Water Control Valve

Water Control Valve

Valve opening temperature

93.5 - 96.5 °C (200 - 206 °F)

Full-open lift amount

More than 8 mm / 108 °C (0.31 in / 226 °F)

Valve closing temperature

90 °C (194 °F) or higher

    Thermostat
    Exploded View Exploded View 1. Water inlet 2. Thermostat assembly 3. Water pump housing 4. Water pump housing gasket 5. Water pump 6. Water pump gasket 7. O-ring A. Refer to Rem...

    Other materials:

    After Replacing ECM
    CHECK ‘OPERATION LOG’ With CONSULT Check Operation Log saved before replacing ECM, according to the procedure of “Programming� in CONSULT Operation Manual. Note: For the Nissan Sentra vehicle that the programming is to be performed ...

    Brake Fluid
    Draining Draining CAUTION: Before working, place the ignition switch in the OFF position and disconnect the harness connector from the ABS actuator and electric unit (control unit) or the negative battery terminal. Refer to Battery Disconnect ...

    High Pressure Fuel Pump
    Component Function Check Component Function Check CHECK HIGH PRESSURE FUEL PUMP FUNCTION With CONSULT Start engine. Select “FUEL PRES SEN V� in “DATA MONITOR� mode of “ENGINE� usi ...