Nissan Sentra Service Manual: Service data and specifications (sds)
General Specification
Drive Belt
Spark Plug
*:Always check with the Parts Department for the latest parts information.
Exhaust Manifold
Camshaft
VALVE LIFTER
VALVE CLEARANCE
*: Approximately 80В°C (176В°F)
AVAILABLE VALVE LIFTER
*:Always check with the Parts Department for the latest parts information.
Cylinder Head
VALVE DIMENSIONS
VALVE GUIDE
VALVE SEAT
*1: Diameter made by intersection point of conic angles “α1” and “α2”
*2: Diameter made by intersection point of conic angles “α2” and “α3”
*3: Machining data
VALVE SPRING
Cylinder Block
AVAILABLE PISTON
*:Always check with the Parts Department for the latest parts information.
PISTON RING
PISTON PIN
CONNECTING ROD
*: After installing in connecting rod
CRANKSHAFT
*: Total indicator reading
Connecting Rod Bearing
CONNECTING ROD BEARING GRADE TABLE
*:Always check with the Parts Department for the latest parts information.
UNDERSIZE TABLE
CONNECTING ROD BEARING OIL CLEARANCE
Main Bearing
MAIN BEARING GRADE TABLE (ALL JOURNALS)
*:Always check with the Parts Department for the latest parts information.
UNDERSIZE TABLE
MAIN BEARING OIL CLEARANCE
How to select piston and bearing
Description
Selection points
Selection parts
Selection items
Selection methods
Between cylinder block and
crankshaft
Main bearing
Main bearing grade (bearing
thi ...
Other materials:
Telescopic operation
Pull the lock lever down 1 and adjust the steering
wheel forward or backward 3 to the desired
position.
Push the lock lever up 1 firmly to lock the
steering wheel in place.
WARNINGDo not adjust the steering wheel any
closer to you than is necessary for proper
steering operation a ...
Eps warning lamp does not turn on
Description
EPS warning lamp does not turn ON when turning ignition switch
ON from OFF. (Check the illumination of the
EPS warning lamp.)
Diagnosis Procedure
1.CHECK EPS WARNING LAMP
Perform the trouble diagnosis of EPS warning lamp. Refer to
STC-31, "Diagnosis Procedure".
Is ...
P050A, P050B, P050E Cold start control
Description
ECM controls ignition timing and engine idle speed when engine is started
with pre-warming up condition.
This control promotes the activation of three way catalyst by heating the
catalyst and reduces emissions.
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC P050A, P050B or P050E ...
