Nissan Sentra B18 (2020-2025) Service Manual: Service

Nissan Sentra B18 (2020-2025) Service Manual / Restraints / Srs Air Bag :: Precaution / Precautions / Service

Service

Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least three minutes.

For approximately three minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least three minutes have passed.
Diagnosis sensor unit must always be installed with their arrow marks “⇐” pointing towards the front of the Nissan Sentra vehicle for proper operation. Also check diagnosis sensor unit for cracks, deformities or rust before installation and replace as required.
The spiral cable must be aligned with the neutral position since its rotations are limited. Do not turn steering wheel and column after removal of steering gear.
Handle air bag module carefully. Always place driver and front passenger air bag modules with the pad side facing upward and seat mounted front side air bag module standing with the stud bolt side facing down.
Conduct self-diagnosis to check entire SRS for proper function after replacing any components.
After air bag inflates, the instrument panel assembly should be replaced if damaged.
Always replace instrument panel pad following front passenger air bag deployment.

Precaution for Supplemental Restraint System (srs) "air Bag" and "seat Belt Pre-Tensioner"

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used alo ...

Precautions for Work

Precautions for Work When removing or disassembling each component, be careful not to damage or deform it. If a component may be subject to interference, be sure to prote ...

Other materials:

Dtc/circuit diagnosis
Power supply and ground circuit Audio unit AUDIO UNIT : Diagnosis Procedure Regarding wiring diagram information, refer to av-88, "wiring diagram". 1.Check fuse Check that the following fuses are not blown. Are the fuses blown? Yes >> replace the blown fuse after repairing ...

Dtc Description
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition ...

P0300 Misfire
Dtc Description DTC Description When a misfire occurs, engine speed will fluctuate. If the engine speed fluctuates enough to cause the crankshaft position (CKP) sensor signal to vary, ECM can determine that a misfire is occurring. ...