Work Procedure

Work Procedure

• Always perform Clutch Point Learning before Select Learning.

• Perform Select Learning with CVT fluid temperature below 50°C (122°F) and again with fluid temperature above 50°C (122°F).

1. PERFORM SELECT LEARNING (DRIVE/REVERSE LEARNING)

   1. Set the parking brake.

   2. Start the engine and wait 5 seconds.

   3. Shift the selector lever to the N position and hold more than 2 seconds, then to D position and wait for transmission engagement.

   4. Repeat step 3 ten (10) times.

   5. Shift the selector lever to the N position and hold more than 2 seconds, then to R position and wait for transmission engagement.

   6. Repeat step 5 ten (10) times.

   7. Shift the selector lever to the P position and turn the ignition OFF.

   >>

   WORK END