Nissan Sentra B18 (2020-2025) Service Manual: Removal and Installation
Av Control Unit
Exploded View
Exploded View
|
1. |
AV control unit bracket (LH) |
2. |
AV control unit |
3. |
AV control unit bracket (RH) |
Removal and Installation
Removal and Installation
REMOVAL
CAUTION:
When replacing AV control unit, perform "ADDITIONAL SERVICE WHEN REPLACING AV CONTROL UNIT. Refer to Work Procedure (Without BOSE®) or Work Procedure (With BOSE®).
Disconnect the negative battery terminal. Refer to Battery Disconnect.
Remove cluster lid C. Refer to Removal and Installation
Remove the AV control unit screws, then pull out the AV control unit.
Disconnect the harness connectors from the AV control unit and remove.
If necessary, remove the AV control unit bracket (LH/RH) screws and the AV control unit brackets (LH/RH).
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
When replacing AV control unit, perform "ADDITIONAL SERVICE WHEN REPLACING AV CONTROL UNIT". Refer to Work Procedure (Without BOSE®) or Work Procedure (With BOSE®).
Rear View Camera
Removal and Installation
Removal and Installation
Removal
Remove trunk lid finisher. Refer to Removal and Installation.
Remove
trunk lid damper bolts (A) and trunk lid damper (1). 
Disconnect the rear view camera harness connector.
Using a
suitable tool, release pawl and remove rear view camera (1). 
Installation
Installation is in the reverse order of removal.
Note:
Perform camera image calibration. Refer to Description.
Other materials:
P059f Active Grille Shutter
Dtc Description
DTC Description
DTC DETECTION LOGIC
Active grille shutter normally stops within zone which
is defined by zone (90°±20°).
If the active grille shutter stops within zone stuck
error is detected, and if the active grille shutter stops at position beyond
zon ...
Rear Axle. Periodic Maintenance. Rear Wheel Hub. Inspection
Rear Wheel Hub. Inspection
Inspection
Inspection
COMPONENT PART
Check the mounting conditions (looseness, back
lash) of each component and component conditions (wear, damage) are
normal.
WHEEL HUB ASSEMBLY (BEARING-INTEGRATED
TYPE)
Check the following items, and replace the p ...
Component Parts
Ipdm E/r (intelligent Power Distribution Module Engine Room)
Component Parts Location
Component Parts
Location
A.
Engine compartment LH
...