Nissan Sentra B18 (2020-2025) Service Manual: Removal and Installation
Warning:
-
Before servicing the SRS, place the ignition switch in the OFF position, disconnect both battery terminals then wait at least three minutes.
-
Do not use air tools or electric tools for servicing the front seat belt buckle switch.
The front seat belt buckle switch is serviced as part of the front seat belt buckle. For removal and installation of the front seat belt buckle, refer to Removal and Installation.
Other materials:
Auto operation does not operate but manual operate normally (driver side)
Diagnosis Procedure
1.PERFORM INITIALIZATION PROCEDURE
Initialization procedure is executed and operation is confirmed.
Refer to PWC-29, "Work Procedure".
Is the inspection result normal?
YES >> INSPECTION END
NO >> GO TO 2.
2.CHECK ENCODER CIRCUIT
Check encoder cir ...
Rear View Camera
Removal and Installation
Removal and Installation
Removal
Remove
trunk lid finisher. Refer to Removal and Installation.
Remove
trunk lid damper bolts (A) and trunk lid damper (1).
Disconnect
the rear view camera harness connector.
Using a
suitable tool, release pa ...
Dtc Confirmation Procedure
DTC Confirmation
Procedure
PERFORM SELF DIAGNOSTIC RESULT
CONSULT
Select “Self Diagnostic Result” mode of “BCM(AIR
PRESSURE MONITOR)”.
Is DTC “C1700-54” detected?
YES >>
Refer to DTC ...
