Nissan Sentra Service Manual: Removal and installation

Squeak and rattle trouble diagnoses

Work Flow Customer interview Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the diagnostic worksheet during the interview to document th ...

Glass lid

Exploded view Glass lid Roof panel Front Removal and installation Removal Caution: After installing glass lid, check gap/height adjustments and operation to make sure there is ...

Other materials:

P0500 VSS
EXCEPT FOR M/T MODELS EXCEPT FOR M/T MODELS : Description ECM receives vehicle speed signals from two different paths via CAN communication line: One is from the ABS actuator and electric unit (control unit) via the combination unit and the other is from TCM. EXCEPT FOR M/T MODELS : DTC Logi ...

P1650 Starter motor relay 2
Description ECM controls ON/OFF state of the starter relay, according to the engine and vehicle condition. ECM transmits a control signal to IPDM E/R via BCM by CAN communication. Under normal conditions, ECM controls and maintains the starter relay in OFF state during following condition: ...

Thermostat and thermostat housing
Exploded View Thermostat housing Gasket Rubber ring Thermostat Water inlet Clamp Radiator hose (upper) To radiator WARNING: Do not remove the radiator cap when the engine is hot. Serious burns could occur from high-pressure engine coolant escaping from the radiator. ...