Nissan Sentra B18 (2020-2025) Service Manual: Rear Axle :: Service Data and Specifications (sds)
Inspection
Inspection
INSPECTION AFTER REMOVAL
Check the
wheel hub assembly for wear, cracks, and damage.
Replace if
necessary.
INSPECTION AFTER INSTALLATION
Check wheel sensor harness fo ...
Other materials:
Inspection
Inspection
INSPECTION
MAGNETIC SWITCH
Remove
starter motor from vehicle. Refer to Removal and Installation.
Connect 12V
battery to starter motor as shown. Check that pinion gear (1) is
driven out by magnetic switch.
Replace starter motor if pinion gear is ...
Additional service when replacing ecm
Description
When replacing ECM, the following procedure must be performed. (For details,
refer to EC-135, "Work Procedure".)
PROGRAMMING OPERATION
NOTE:
After replacing with a blank ECM, programming is required to write ECM
information. Be sure to follow the procedure
to perform t ...
Inspection
Inspection
DESCRIPTION
Measure the wheel alignment under unladen
conditions.
Note:
“Unladen conditions” means that fuel,
engine coolant, and lubricants are full. Spare tire, jack, hand
tools and mats are in designated positions.
PRELIMINARY
Check the following:
Tires ...
