Nissan Sentra Service Manual: Precaution
Precautions for Trouble Diagnosis
Caution:
Follow the instructions listed below. Failure to do this may cause damage to parts:
- Never apply 7.0 V or more to the measurement terminal.
- Use a tester with open terminal voltage of 7.0 V or less.
- Turn the ignition switch off and disconnect the battery cable from the negative terminal when checking the harness.
Precautions for Harness Repair
- Solder the repaired area and wrap tape around the soldered area.
Note:
A fray of twisted lines must be within 110 mm (4.33 In).
- Bypass connection is never allowed at the repaired area.
Note:
Bypass connection may cause can communication error. The spliced wire becomes separated and the characteristics of twisted line are lost.
- Replace the applicable harness as an assembly if error is detected on the shield lines of can communication line.
How to use this manual
Information
“Can fundamental” of lan section describes the basic knowledge of the
can communication system
and the method of trouble diagnosis.
For information peculiar to a vehic ...
System description
System
Can communication system
Can communication system : system description
CAN (Controller Area Network) is a serial communication line for real time
application. It is an on-vehicle multiplex ...
Other materials:
Instrument panel assembly
Exploded View
Instrument panel assembly
Ambient sensor
Defroster grille (RH)
Defroster grille (LH)
Sunload sensor (if equipped)
Side defroster grille (LH)
Instrument side finisher (LH)
Side ventilator grille (LH)
Steering column upper cover
Combination switch
Steering col ...
Diagnosis system (bcm) (with intelligent
key system)
Common item
Common item : consult function (bcm -
common item)
APPLICATION ITEM
CONSULT performs the following functions via CAN communication with BCM.
Direct Diagnostic Mode
Description
ECU identification
The BCM part number is displayed.
Self Diagnostic Result
...
P0441 EVAP Control system
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC P0441 is displayed with other DTC such as P2122, P2123, P2127,
P2128 or P2138, first perform
trouble diagnosis for other DTC.
In this evaporative emission (EVAP) control system, purge flow occurs during
non-closed throttle conditions.
Purge volu ...
