Nissan Sentra manuals

Nissan Sentra Service Manual: Periodic maintenance

Symptom diagnosis
Noise, vibration and harshness (nvh) troubleshooting NVH Troubleshooting Chart Use chart below to find the cause of the symptom. If necessary, repair or replace these parts. ×: Applicab ...

Rear suspension assembly
Inspection COMPONENT PART Check the mounting conditions (looseness, backlash) of each component. Verify the component conditions (wear, damage) are normal. SHOCK ABSORBER Check the shock absorb ...

Other materials:

Environmental factors influence the rate of corrosion
Moisture Accumulation of sand, dirt and water on the vehicle body underside can accelerate corrosion. Wet floor coverings will not dry completely inside the vehicle and should be removed for drying to avoid floor panel corrosion. Relative humidity Corrosion will be accelerated in areas of h ...

Cooling fan
Component Function Check 1.CHECK COOLING FAN FUNCTION With CONSULT Turn ignition switch ON. Perform “FAN” in “ACTIVE TEST” mode of “ENGINE” using CONSULT Check that cooling fan operates at low speed or high speed. Without CONSULT Activate IPDM E/R auto ...

Readiness for inspection/maintenance (I/M) test
Due to legal requirements in some states and Canadian Provinces, your vehicle may be required to be in what is called the “ready condition” for an Inspection/Maintenance (I/M) test of the emission control system. The vehicle is set to the “ready condition” when it is driven through c ...

© 2014-2025 Copyright www.nisentra.com