Nissan Sentra manuals

Nissan Sentra Service Manual: Periodic maintenance

Nissan Sentra Service Manual / Transmission & driveline / Transaxle & transmission / 6MT: RS6F94R / Periodic maintenance

M/T OIL

Inspection

OIL LEAKAGE

Make sure that gear oil is not leaking from transaxle or around it.

OIL LEVEL

  1. Remove filler plug (1) and gasket from transaxle case.
  2. Check the oil level from filler plug mounting hole as shown.

CAUTION:

Do not start engine while checking oil level.

  1. Set a gasket on filler plug and then install it to transaxle case.

CAUTION:

Do not reuse gasket.

  1. Tighten filler plug to the specified torque. Refer to TM-30 "Exploded View".

CAUTION:


CAUTION:

Do not overtighten the filler plug as this could cause the transaxle case to crack.

Draining

  1. Start engine and let it run to warm up transaxle
  2. Stop engine. Remove drain plug (1) and gasket, using a suitable tool and then drain gear oil.
  3. Set a gasket on drain plug and install it to clutch housing, using a suitable tool.

CAUTION:

Do not reuse gasket.

  1. Tighten drain plug to the specified torque. Refer to TM-30, "Exploded View".

CAUTION:

Do not overtighten the filler plug as this could cause the transaxle case to crack.

Refilling


Refilling

  1. Remove filler plug (1) and gasket from transaxle case.
  2. Fill with new gear oil until oil level reaches the specified limit at filler plug mounting hole as shown.

Oil grade and viscosity : Refer to MA-11, "Fluids and Lubricants".

Oil capacity : Refer to MA-11, "Fluids and Lubricants".


  1. After refilling gear oil, check the oil level. Refer to TM-19, "Inspection".
  2. Set a gasket on filler plug and then install it to transaxle case.

CAUTION:

Do not reuse gasket.

  1. Tighten filler plug to the specified torque. Refer to TM-30, "Exploded View".

CAUTION:

Do not overtighten the filler plug as this could cause the transaxle case to crack.

Symptom diagnosis
NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING NVH Troubleshooting Chart Use the chart below to find the cause of the symptom. The numbers indicate the order of the inspection. If necessary ...

Removal and installation
SIDE OIL SEAL Removal and Installation REMOVAL Remove front drive shafts. Refer to FAX-18, "6M/T : Removal and Installation (LH)". Remove differential side oil seals (1) from clu ...

Other materials:

Brake pedal
Adjustment BRAKE PEDAL HEIGHT Remove instrument lower panel LH. Refer to IP-21, "Removal and Installation". Disconnect the harness connectors from the brake pedal position switch (if equipped) and the stop lamp switch. Turn the stop lamp switch and brake pedal position swi ...

Diagnosis system (BCM) (with intelligent key system)
Common item COMMON ITEM : CONSULT Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT performs the following functions via CAN communication with BCM. Direct Diagnostic Mode Description ECU identification The BCM part number is displayed. Self Diagnostic Result ...

Basic inspection
DIAGNOSIS AND REPAIR WORK FLOW Work Flow NOTE: “DTC” includes DTC at the 1st trip. 1.OBTAIN INFORMATION ABOUT SYMPTOM Refer to TM-140, "Diagnostic Work Sheet" and interview the customer to obtain the malfunction information (conditions and environment when the malfunctio ...

© 2014-2026 Copyright www.nisentra.com