Adjustment - Drum Brake
If equipped with drum brakes, refer to PB-11, "Inspection and Adjustment".
Adjustment - Disc Brake
Adjust parking brake lever stroke. Refer to PB-4, "Inspection and Adjustment".
Perform parking brake break-in (drag on) operation by driving vehicle under the following conditions:
Drive forward
Vehicle speed: Approx. 43 km/h (27 MPH) set (constant and forward)
Parking brake operating force: 125 N (12.8 kg-f, 28.1 lb-f) set contact
Time: Approx. 8 sec.
CAUTION:
To prevent lining from getting too hot, allow a cool off period of approximately 5 minutes after every break-in operation.
After the break-in procedure, check parking brake lever stroke.
CAUTION:
If it is out of the specification, adjust again. Refer to PB-4, "Inspection and Adjustment".
Revision:
Parking brake systemDescription
NOTICE:
Trouble diagnoses indicate work procedures required to diagnose problems
effectively. Observe the following
instructions before diagnosing.
Before performing trouble diagnoses, read the “Work Flow” in each
section.
After repairs, re-check that the problem has been comp ...
Diagnosis system (BCM)
Common item
Common item : consult function (bcm - common item)
APPLICATION ITEM
CONSULT performs the following functions via CAN communication with BCM.
SYSTEM APPLICATION
BCM can perform the following functions.
Intelligent key
Intelligent key : consult function (bcm - intelligent ke ...
Abs branch line circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the abs actuator and electric unit
(control unit) for damage, bend
and loose connection (unit side and connector side).
...