Nissan Sentra B18 (2020-2025) Service Manual: P060b Ecm

Nissan Sentra B18 (2020-2025) Service Manual / Engine / Work Procedure (After Replacing Electric Throttle Control Actuator) / Dtc/circuit Diagnosis / P060b Ecm

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC	CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
P060B	CONTROL MODULE (Internal control module A/D processing performance)	Diagnosis condition	Ignition switch ON
		Signal (terminal)	—
		Threshold	ECM internal analog/digital conversion processing system is malfunctioning
		Diagnosis delay time	—

POSSIBLE CAUSE

ECM

FAIL-SAFE

Engine Control System

Engine operating condition in fail-safe mode
Fail safe mode		Nissan Sentra Vehicle behavior
Device fix mode		This mode fixes the electric IVT motor and the EVT control solenoid valve in the reference position. The intake manifold runner control valve motor is turned OFF (intake manifold runner control valve opens).

Idle Start/Stop System

When a DTC is detected, the start/stop indicator lamp blinks slowly and the idle start/stop system operation is prohibited.

When ECM detects error while operating the idle start/stop system, ECM restarts the engine.

Confirmation Procedure

Confirmation Procedure

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is 11 V or more with ignition switch ON.

>>
GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE
1. Turn ignition switch ON (engine stopped) and wait least 10 seconds.
  
  CAUTION:
  
  Never start engine during this procedure.
2. Turn ignition switch OFF and wait at least 10 seconds.
3. Turn ignition switch ON.
4. Check DTC.
Is DTC detected?
YES >>
Proceed to DTC Diagnosis Procedure.
NO-1 >>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2 >>
Confirmation after repair: INSPECTION END

Dtc Diagnosis Procedure

DTC Diagnosis Procedure

PERFORM DTC CONFIRMATION PROCEDURE
1. Turn ignition switch ON.
2. Erase DTC.
3. Perform DTC confirmation procedure. Refer to Confirmation Procedure.
Is the DTC P060B displayed again?
YES >>
Replace ECM. Refer to ECM : Removal & Installation.
NO >>
INSPECTION END

P060a Ecm

Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble ...

P060c Ecm

Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble ...

Other materials:

Preparation
Special Service Tools NOTE: The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here. Commercial Service Tools ...

Engine Oil Pressure Sensor
Component Inspection Component Inspection CHECK EOP SENSOR Turn ignition switch OFF. Disconnect EOP sensor harness connector. Check resistance between EOP sensor connector termi ...

Symptom diagnosis
Combination switch system symptoms Symptom Table Perform the data monitor of consult to check for any malfunctioning item. Check the malfunction combinations. Identify the malfunctioning part from the agreed combination and repair or replace the part. ...