Nissan Sentra B18 (2020-2025) Service Manual: Hoses
Hoses
HOSE REMOVAL AND INSTALLATION
-
To prevent damage to rubber hose, do not pry off rubber hose with tapered tool or screwdriver.
-
To reinstall the rubber hose securely, make sure that hose insertion length and orientation is correct. (If tube is equipped with hose stopper, insert rubber hose into tube until it butts up against hose stopper.)
HOSE CLAMPING
-
If old rubber hose is re-used, install hose clamp in its original position (at the indentation where the old clamp was). If there is a trace of tube bulging left on the old rubber hose, align rubber hose at that position.
-
Discard old clamps; replace with new ones.
-
After installing plate clamps, apply force to them in the direction of the arrow, tightening rubber hose equally all around.
Other materials:
P0315 Ckp Sensor (pos)
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis
content)
DTC detection
condition
...
Clutch Master Cylinder (clutch Switch)
Component Function Check
Component Function Check
CHECK FUNCTION
CONSULT
Ignition switch ON.
Select “INTELLIGENT KEY” mode of
“BCM”.
...
Ecu Diagnosis Information. Abs Actuator and Electric Unit (control Unit)
Abs Actuator and Electric Unit (control Unit)
Values on the Diagnosis Tool
Values on the
Diagnosis Tool
Note:
The following table includes information (items)
inapplicable to this Nissan Sentra vehicle: For information (items) applicable to
this vehicle, refer to CONSULT display ...