Nissan Sentra manuals

Nissan Sentra B18 (2020-2025) Service Manual: Hfo-1234yf (r-1234yf) Service Tool and Equipment

HFO-1234yf (R-1234yf) Service Tool and Equipment

Do not mix HFO-1234yf (R-1234yf) refrigerant and/or its specified oil with HFC-134a (R-134a) or CFC-12 refrigerant and/or its oil.

Separate and non-interchangeable service equipment must be used for handling each type of refrigerant/oil.

Refrigerant container fittings, service hose fittings and service equipment fittings (equipment which handles refrigerant and/or oil) are different between HFC-134a (R-134a), CFC-12 (R-12) and HFO-1234yf (R-1234yf). This is to avoid mixed use of the refrigerants/oil.

Adapters that convert one size fitting to another must not be used refrigerant/oil contamination will occur and compressor failure will result.

Tool number

(TechMate No.)

Tool name

Description

( — )

(NI-43926)

Refrigerant dye leak detection kit

Kit includes:

  • UV lamp and UV safety goggles

  • Refrigerant dye injector

  • Fluorescent leak detection dye

    (box of 24, 1/4 ounce bottles)

  • Refrigerant dye cleaner

Power supply:

  • DC 12V (battery terminal)

(NI-52990)

Fluorescent Oil Dye

—

(NI-52405)

NISSAN ACR2009 RRR Unit

Refrigerant recovery, recycling and recharging

Special Service Tool
Special Service Tool The actual shape of the tools may differ from those illustrated here. Tool number (TechMat ...

Commercial Service Tool
Commercial Service Tool (TechMate No.) Tool name Description ...

Other materials:

Preparation
Commercial Service Tools Commercial Service Tools Tool name   Description Oil filter wrench assortment ...

P0420 Three Way Catalyst Function
Dtc Description DTC Description The ECM monitors the switching frequency ratio of air fuel ratio (A/F) sensor 1 and heated oxygen sensor 2. A three way catalyst (manifold) with high oxygen storage capacity will indicate a low switching frequency of heated oxygen sensor 2. As oxygen ...

Installing front license plate
Use the following steps to mount the front license plate: Make holes on the plastic finisher at the location mark (small dimple) using a 0.20 in (5 mm) drill. Apply light pressure to the drill. Install the license plate holder using the two screws provided with the holder. Mount ...

© 2014-2026 Copyright www.nisentra.com