FAIL-SAFE CONTROL BY DTC
BCM performs fail-safe control when any DTC are detected.
|
Display contents of CONSULT |
Fail-safe |
|---|---|
|
B2C21-23: Seat belt buckle switch (driver side) |
Inhibit idle start/stop system |
|
B2C41-04: Power window motor FL |
Front power window motor LH operation is stop or inching |
|
B2C95-01: Combination switch |
Headlamp ON (low beam) |
|
B2C95-64: Combination switch |
Headlamp ON (low beam) |
|
B2F60-55: Seat belt buckle switch (driver side) |
Inhibit idle start/stop system |
|
B2FAE-12: Ignition relay |
Inhibit engine cranking |
|
B2FAE-14: Ignition relay |
Inhibit engine cranking |
|
U1C02-08: LIN communication |
Front power window motor LH operation is stop |
FAIL-SAFE CONTROL OF COMBINATION SWITCH READING FUNCTION CAUSED BY LOW POWER SUPPLY VOLTAGE
If battery power supply voltage lowers, the BCM maintains the combination switch reading status to the status when input voltage was less than approximately 9 V.
Note:
When battery power supply voltage is approximately 9 V or more, the combination switch reading function returns to normal operation.
Reference Value
Dtc Inspection Priority ChartTcm
Reference Value
Reference Value
CONSULT DATA MONITOR STANDARD VALUE
In CONSULT, electric shift timing or lock-up timing, i.e.
operation timing of each solenoid valve, is displayed. Therefore, if
there is an obvious difference between the shift timing estimated from ...
Removal and Installation
Removal and Installation
REMOVAL
Warning:
Before servicing the SRS, place the ignition
switch in the OFF position, disconnect both battery terminals then
wait at least three minutes.
Do not use air tools or electric tools for
...
Exploded View
Exploded View
1.
Instrument panel
assembly
2.
Front passenger air bag
module
...