Nissan Sentra B18 (2020-2025) Service Manual: Engine Coolant Temperature Sensor
Component Inspection
Component Inspection
-
CHECK ENGINE COOLANT TEMPERATURE SENSOR
-
Turn ignition switch OFF.
-
Disconnect engine coolant temperature sensor harness connector.
-
Remove engine coolant temperature sensor. Refer to Exploded View.
-
Check the resistance between engine coolant temperature sensor terminals by heating with hot water as shown in the figure.
ECT sensor
Condition
Resistance
Terminal
1
2
Temperature [°C (°F)]
20 (68)
2.37 – 2.63 kΩ
50 (122)
0.68 – 1.00 kΩ
90 (194)
0.236 – 0.260 kΩ
Is the inspection result normal?
YES >>INSPECTION END
NO >>Replace engine coolant temperature sensor. Refer to Exploded View.
-
Other materials:
U1010-49 Control Unit(can)
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
...
Precaution. Precautions
Precautions
Precautions for Supplemental Restraint System (srs) "air Bag" and "seat Belt Pre-Tensioner"
Precautions for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as
“AIR BAG” and “SEAT BELT PRE-TENSIONER”,
...
Uniform tire quality grading
DOT (Department of Transportation) Quality Grades apply to all passenger car
tires and are intended to provide comparative information in addition to meeting
federal safety requirements.
Where applicable, these quality grades are molded into the tire sidewall between
the tread shoulder and th ...