Nissan Sentra manuals

Nissan Sentra Service Manual: Ecm branch line circuit

Diagnosis Procedure

1.CHECK CONNECTOR

  1. Turn the ignition switch OFF.
  2. Disconnect the battery cable from the negative terminal.
  3. Check the terminals and connectors of the ECM for damage, bend and loose connection (unit side and connector side).

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair the terminal and connector.

2.Check harness for open circuit

  1. Disconnect the connector of ecm.
  2. Check the resistance between the ecm harness connector terminals.

Is the measurement value within the specification?


Is the measurement value within the specification? Yes >> go to 3.

No >> repair the ecm branch line.

3.Check power supply and ground circuit

Check the power supply and the ground circuit of the ECM. Refer to EC-164, "Diagnosis Procedure".

Is the inspection result normal? YES (Present error)>>Replace the ECM. Refer to EC-485, "Removal and Installation".

YES (Past error)>>Error was detected in the ECM branch line.

NO >> Repair the power supply and the ground circuit.

Main line between dlc and av circuit
Diagnosis procedure 1.Check harness continuity (open circuit) Turn the ignition switch off. Disconnect the battery cable from the negative terminal. Disconnect the following harness connector ...

Abs branch line circuit
Diagnosis procedure 1.Check connector Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the abs actuator and electri ...

Other materials:

Removal and installation
OIL COOLER Exploded View M/T models Clamp Water hose Clamp Water hose Oil cooler O-rings CVT models Clamp Water hose Clamp Water hose Water hose clip Oil cooler Clamp Water hose O-rings To CVT oil warmer Removal and Installation REMOVAL Re ...

P0447 EVAP Canister vent control valve
DTC Logic DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possible cause P0447 VENT CONTROL VALVE (Evaporative emission system vent control circuit open) An improper voltage signal is sent to ECM throug ...

Ignition switch (if so equipped)
WARNING Never remove or turn the key to the LOCK position while driving. The steering wheel will lock (for models with a steering lock mechanism). This may cause the driver to lose control of the vehicle and could result in serious vehicle damage or personal injury ...

В© 2014-2026 Copyright www.nisentra.com