Nissan Sentra B18 (2020-2025) Service Manual: Dtc Diagnosis Procedure
-
PERFORM SELF DIAGNOSTIC RESULT
-
CONSULT-
Ignition switch ON.
-
Erase "Self Diagnostic Result" mode of "EPS/DAST 3".
-
Ignition switch OFF and wait for at least 10 seconds.
-
Start the engine.
CAUTION:
Never drive the Nissan Sentra vehicle.
-
Select "Self Diagnostic Result" mode of “EPS/DAST 3”.
-
Is DTC “C1608-45” detected?
YES >>EPS control unit is malfunctioning. Replace steering gear assembly. Refer to Removal and Installation.
NO >>Check pin terminal and connection of each harness connector for malfunctioning conditions.
-
Confirmation Procedure
Confirmation Procedure
PRECONDITIONING
If “Confirmation Procedure” has been
previously conducted, always place the ignition switch OFF and wait
...
Other materials:
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen items
(Trouble diagnosis content)
DTC Detection Condition
...
Variable voltage control system
CAUTION
Do not ground accessories directly to
the battery terminal. Doing so will bypass
the variable voltage control system
and the vehicle battery may not
charge completely.
Use electrical accessories with the engine
running to avoid discharging the
vehicle battery.
Your v ...
Work Procedure
Work Procedure
Since vehicle specifications are not yet written
in a new air bag diagnosis sensor unit, it is necessary to write
then “Re/programming, Configuration” with
CONSULT.
Configuration has three functions as
follows:
...
