Nissan Sentra B18 (2020-2025) Service Manual: C1608-46 Control Unit
Dtc Description
DTC Description
DTC DETECTION LOGIC
|
DTC No. |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition |
|
|---|---|---|---|
|
C1608–46 |
CONTROL UNIT (Control unit) |
Diagnosis condition |
When ignition switch is ON. |
|
Signal (terminal) |
- |
||
|
Threshold |
When the malfunction is detected in EPS control unit calibration data. |
||
|
Diagnosis delay time |
1 second or more |
||
POSSIBLE CAUSE
EPS control unit
FAIL-SAFE
Normal control
Confirmation Procedure
Confirmation Procedure
-
PRECONDITIONING
-
If “Confirmation Procedure� has been previously conducted, always place the ignition switch OFF and wait at least 10 seconds before conducting the next test.
GO TO 2.
-
-
DTC REPRODUCTION PROCEDURE
-
CONSULT-
Start the engine.
CAUTION:
Never drive the Nissan Sentra vehicle.
-
Select "Self Diagnostic Result" mode of “EPS/DAST 3�.
-
Is DTC “C1608-46� detected?
YES >>Proceed to diagnosis procedure. Refer to DTC Diagnosis Procedure.
NO >>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO >>Confirmation after repair: Inspection End.
-
Dtc Diagnosis Procedure
DTC Diagnosis Procedure
-
PERFORM SELF DIAGNOSTIC RESULT
-
CONSULT-
Ignition switch ON.
-
Erase "Self Diagnostic Result" mode of "EPS/DAST 3".
-
Ignition switch OFF and wait for at least 10 seconds.
-
Start the engine.
CAUTION:
Never drive the Nissan Sentra vehicle.
-
Select "Self Diagnostic Result" mode of “EPS/DAST 3�.
-
Is DTC “C1608-46� detected?
YES >>EPS control unit is malfunctioning. Replace steering gear assembly. Refer to Removal and Installation.
NO >>Check pin terminal and connection of each harness connector for malfunctioning conditions.
-
Other materials:
Dtc Index
DTC Index
Self Diagnostic
Result
DTC
Diagnostic item
SRS air bag warning lamp
Reference
...
P2096 A/f Sensor 1
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis
content)
DTC detection
condition
...
Trip Reset Switch Signal Circuit
Diagnosis Procedure
Diagnosis Procedure
CHECK TRIP RESET SWITCH SIGNAL
Ignition switch ON.
Check voltage between the following terminals of
the trip reset switch harness con ...