Nissan Sentra B18 (2020-2025) Service Manual: Dtc Confirmation Procedure

Nissan Sentra B18 (2020-2025) Service Manual / Steering / Steering System :: Dtc/circuit Diagnosis / B24f4-12 Steering Heater Relay / Dtc Confirmation Procedure

DTC Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE
1. CONSULT
  1. Ignition switch ON.
  2. Turn heated steering wheel ON.
  3. Select “Self Diagnostic Result” mode of “HVAC”.
Is B24F4–12 detected?
YES>>
Refer to DTC Diagnosis Procedure.
NO>>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>
Confirmation after repair: Inspection End.

Dtc Description

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis na ...

Dtc Diagnosis Procedure

DTC Diagnosis Procedure CHECK FUSE Ignition switch OFF. Check that any of the following ...

Other materials:

Removal and Installation
Removal and Installation REMOVAL Disconnect the battery negative terminal. Refer to Battery Disconnect. Remove intake manifold. Refer to Removal and Installation. Partially remove front fender protector (RH). Refer to Exploded View — Front Fender Protector. Remove ...

Front Camera Unit
Values on the Diagnosis Tool Values On The Diagnosis Tool Note: The following table includes information (items) inapplicable to this Nissan Sentra vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items. ...

Adjustment of Steering Angle Sensor Neutral Position
Description Description Refer to the table below to determine if adjustment of steering angle sensor neutral position is required. ×: Required –: Not required Situation Adjustment of steering angle ...