Nissan Sentra manuals

Nissan Sentra B18 (2020-2025) Service Manual: Diagnosis Procedure

Diagnosis Procedure

  1. CHECK THE ILLUMINATION OF THE EPS WARNING LAMP

    1. Check the EPS warning lamp while engine is running.

    Does the EPS warning lamp turn OFF?

    YES>>

    GO TO 2.

    NO>>

    Refer to Diagnosis Procedure.

  2. CHECK WHEEL ALIGNMENT

      1. Check the wheel alignment. Refer to Wheel Alignment (Unladen1).

      2. Select “Self Diagnostic Result” mode of “EPS/DAST 3”.

    Is the inspection result normal?

    YES>>

    GO TO 3.

    NO>>

    Adjustment of wheel alignment. Refer to Wheel Alignment (Unladen1).

  3. CHECK EPS CONTROL UNIT SIGNAL

    1. CONSULT

      1. Start the engine.

        CAUTION:

        Never drive the Nissan Sentra vehicle.

      2. Turn steering wheel from full left stop to full right stop.

      3. Select “Steering torque” in “Data Monitor” mode of “EPS/DAST 3”.

      4. Perform the torque sensor inspection.

        Monitor item

        Condition

        Display value

        STEERING TORQUE

        Steering wheel: Not steering (There is no steering force)

        Approx. 0 Nm

        Steering wheel: Right turn

        Positive value (Nm)

        Steering wheel: Left turn

        Negative value (Nm)

    Is the inspection result normal?

    YES>>

    GO TO 5.

    NO>>

    GO TO 4.

  4. CHECK EPS MOTOR

    1. Perform the trouble diagnosis of EPS motor. Refer to DTC Diagnosis Procedure.

    Is the inspection result normal?

    YES>>

    GO TO 5.

    NO>>

    Repair or replace the specific malfunctioning part.

  5. CHECK STEERING WHEEL TURNING FORCE

    1. Check the steering wheel turning force. Refer to Inspection.

    Is the inspection result normal?

    YES>>

    Inspection End.

    NO>>

    Check the steering wheel turning force for mechanical malfunction. Refer to Inspection.

Unbalance Steering Wheel Turning Force (torque Variation)
...

Other materials:

Component Parts
Ipdm E/r (intelligent Power Distribution Module Engine Room) Component Parts Location Component Parts Location A. Engine compartment LH ...

Front disc brake
Exploded View Cap Bleeder valve Cylinder body Piston seal Piston Piston boot Upper sliding pin Lower sliding pin Sliding pin boot Bushing Torque member Apply brake fluid Apply rubber grease Disassembly and Assembly DISASSEMBLY Place a wooden block as shown, and ...

EPS Warning lamp
Component Function Check 1.CHECK THE ILLUMINATION OF THE EPS WARNING LAMP Check that the EPS warning lamp turns ON when ignition switch turns ON. Then, EPS warning lamp turns OFF after the engine is started. Is the inspection result normal? YES >> Inspection End. NO >> Perfo ...

© 2014-2026 Copyright www.nisentra.com