Nissan Sentra B18 (2020-2025) Service Manual: Confirmation Procedure

Nissan Sentra B18 (2020-2025) Service Manual / Steering / Steering Control System :: Dtc/circuit Diagnosis / C1608-44 Control Unit / Confirmation Procedure

Confirmation Procedure

PRECONDITIONING
1. If “Confirmation Procedure” has been previously conducted, always place the ignition switch OFF and wait at least 10 seconds before conducting the next test.
>>
GO TO 2.
DTC REPRODUCTION PROCEDURE
1. CONSULT
  1. Start the engine.
    
    CAUTION:
    
    Never drive the Nissan Sentra vehicle.
  2. Select "Self Diagnostic Result" mode of “EPS/DAST 3”.
Is DTC “C1608-44” detected?
YES >>
Proceed to diagnosis procedure. Refer to DTC Diagnosis Procedure.
NO >>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO >>
Confirmation after repair: Inspection End.

Dtc Description

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis cont ...

Dtc Diagnosis Procedure

DTC Diagnosis Procedure PERFORM SELF DIAGNOSIS RESULT CONSULT Ignition switch ON. ...

Other materials:

Diagnosis and Repair Workflow
Work Flow Work Flow OVERALL SEQUENCE Reference 1··· Refer to CONSULT Function. Reference 2··· Refer to DTC Index. Reference 3··· Refer to Symptom Table. DETAILED FLOW INTERVIEW AND SYMPTOM CONFIRMATION ...

Diagnosis Procedure
Diagnosis Procedure REPLACE A/C SWITCH ASSEMBLY Ignition switch OFF. Replace A/C switch assembly (rear window defogger switch). Refer to Removal and Installation (with automati ...

Outside Key Antenna (rear Bumper)
Removal and Installation Removal and Installation REMOVAL Remove rear bumper. Refer to Removal and Installation. Disconnect the harness connector from the outside key antenna [rear bumper (1)]. Release clips (A) and remove outside key antenna (rear bumper). INS ...