Nissan Sentra B18 (2020-2025) Service Manual: Confirmation Procedure

Nissan Sentra B18 (2020-2025) Service Manual / Steering / Steering Control System :: Dtc/circuit Diagnosis / C1601-17 Battery Power Supply / Confirmation Procedure

Confirmation Procedure

PRECONDITIONING
1. If “Confirmation Procedure” has been previously conducted, always place the ignition switch OFF and wait at least 10 seconds before conducting the next test.
>>
GO TO 2.
DTC REPRODUCTION PROCEDURE
1. CONSULT
  1. Ignition switch ON.
  2. Select "Self Diagnostic Result" mode of “EPS/DAST 3”.
Is DTC “C1601-17” detected?
YES>>
Proceed to diagnosis procedure. Refer to DTC Diagnosis Procedure.
NO>>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>
Confirmation after repair: Inspection End.

Dtc Description

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis cont ...

Dtc Diagnosis Procedure

DTC Diagnosis Procedure CHECK EPS CONTROL UNIT POWER SUPPLY AND GROUND CIRCUIT Check the EPS control unit power supply and ground circuit. R ...

Other materials:

Leak Test
Leak Test CHECK REFRIGERANT LEAKAGE USING FLUORESCENT LEAK DETECTION DYE Install a fender cover (1). Wear UV safety goggles (2) provided with refrigerant dye leak detection kit (NI-43926). Connect power cable (4) of UV lamp (6) to positive and negative terminal ...

C106e-01 Steering Angle Sensor
Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen item (Trouble diagnosis content) DTC detection condition ...

P0016 Intake Valve Timing Control
Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition ...