Moonroof
Moonroof : component parts location
Moonroof : component description
Component |
Function |
Bcm | Supplies the power supply to moonroof motor assembly. |
Moonroof switch | Transmits tilt up/down & slides open/close operation signal to moonroof motor assembly. |
Moonroof motor assembly | The moonroof motor and cpu are integrated into one unit that enables tilt up/down & slide open/ close by moonroof switch operation. |
Front door switch | Detects door open/close condition and transmits to BCM. |
Combination meter | Transmits vehicle speed signal to moonroof motor assembly. |
Diagnosis system (ECM)
Diagnosis description : 1st trip detection
logic and two trip detection logic
When a malfunction is detected for the first time, 1st trip DTC and 1st trip
Freeze Frame data are stored in the
ECM memory. The MIL will not illuminate at this stage. <1st trip>
If the same malfunction is dete ...
Wheel alignment
Inspection
PRELIMINARY INSPECTION
WARNING:
Always adjust the wheel alignment with the vehicle on a flat surface.
NOTE:
If the wheel alignment is out of specification, inspect and replace any
damaged or worn rear suspension parts
before making any adjustments.
Check and adjust the wheel ...
Front drive shaft boot
Exploded View
(LH)
Circular clip
Dust shield
Slide joint housing
Snap ring
Spider assembly
Boot band
Boot
Shaft
Damper band
Dynamic damper
Circular clip
Joint sub-assembly
Wheel side
(RH) 6M/T
Joint sub-assembly
Circular clip
Boot band
Boot
Shaft
Dam ...