Warning:
Always use HFO-1234yf (R-1234yf) for A/C refrigerant. If HFC-134a (R-134a) or CFC-12 (R-12) is accidentally charged, compressor is damaged due to insufficient lubrication.
Always observe and follow precautions described on refrigerant container. Incorrect handling may result in an explosion of refrigerant container, frostbite, or the loss of eyesight.
Do not breathe A/C refrigerant and oil vapor or mist. Exposure my irritate eyes, nose, or throat.
Do not allow HFO-1234yf (R-1234yf) to be exposed to an open flame or others because it generates poisonous gas when in contact with high temperature objects. Keep workshop well ventilated.
Connect recovery/recycling/recharging equipment to the A/C service valve.
Operate recovery/recycling/recharging equipment, and evacuate air from A/C system for 25 minutes or more.
CAUTION:
Evacuate air for 15 minutes or more if the parts are replaced.
Check the airtightness of A/C system for 25 minutes or more. If pressure raises more than the specified level, charge A/C system with approximately 200g refrigerant and check that there is no refrigerant leak. Refer to Leak Test.
CAUTION:
Check the airtightness for 15 minutes or more if the parts are replaced.
If parts other than compressor are replaced, fill compressor oil according to parts that are replaced.
Charge the specified amount of refrigerant to A/C system.
Check that A/C system operates normally.
Disconnect recovery/recycling/recharging equipment. (Collect the refrigerant from the high-pressure hose and low-pressure hose of recovery/recycling/recharging equipment.)
Install A/C service valve cap.
Refrigerant charge is complete.
Recycle Refrigerant
OilInstrument panel
Headlight/turn signal switch for controlling exterior lighting and turn
indicators on the Nissan Sentra
Steering wheel switch
Audio controls for managing volume, media, and hands-free functions without
removing hands from the wheel
Driver's supplemental air bag
Horn integra ...
Clutch pedal
Exploded View
Clutch pedal
Stopper rubber
Clip
Clutch interlock switch (if equipped)
Clutch pedal position switch (if equipped)
Pedal pad
Pedal stopper rubber
Removal and Installation
REMOVAL
Remove instrument lower panel LH. Refer to IP-21, "Removal and
Installa ...
Cluster lid C
Removal and Installation - Cluster Lid C
REMOVAL
Remove cluster lid C lower. Refer to IP-20, "Removal and Installation -
Cluster Lid C Lower".
Remove the cluster lid C screws (A).
Disconnect the harness connector from cluster lid C.
Remove the center ventilator grill ...