Dtc Description
DTC DETECTION LOGIC
|
DTC |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition |
||
|---|---|---|---|---|
|
C1F6B |
4B |
CAMERA UNIT MALF (Camera unit malfunction) |
Diagnosis condition |
|
|
Signal (terminal) |
— |
|||
|
Threshold |
Temperature around front camera unit is excessively high |
|||
|
Diagnosis delay time |
1 second or less |
|||
POSSIBLE CAUSE
Interior room temperature is excessively high
FAIL-SAFE
The following systems are canceled.
AEB
LDW
TSR
I-FCW
Confirmation Procedure
PERFORM DTC CONFIRMATION PROCEDURE
Start the engine.
Turn the AEB system ON.
Perform “All DTC Reading” with CONSULT.
Check if the “C1F6B-4B” is detected as the current malfunction in self-diagnosis results of “ICC/ADAS 2”.
Is “C1F6B-4B” detected as the current malfunction?
YES >>DTC Diagnosis Procedure
NO-1 >>To check malfunction symptom before repair: Intermittent Incident
NO-2 >>Confirmation after repair: INSPECTION END
Dtc Diagnosis Procedure
CHECK FRONT CAMERA UNIT SELF-DIAGNOSIS RESULTS
Check if any DTC is detected in “Self Diagnostic Result” of “LANE CAMERA”.
Is applicable DTC detected?
YES >>Perform diagnosis of applicable. Refer to DTC Index.
NO >>GO TO 2 .
CHECK ADAS CONTROL UNIT 2 SELF-DIAGNOSIS RESULTS
Erase all self-diagnosis results with CONSULT.
Perform “All DTC Reading”.
Check if the “C1F6B-4B” is detected in “Self Diagnostic Result” of “ICC/ADAS 2”
Is “C1F6B-4B” detected?
YES >>Replace the ADAS control unit 2. Removal and Installation
NO >>INSPECTION END
C1f6b-49 Camera Unit
C1f6b-54 Camera UnitEngine compartment
CAUTION
Never use a fuse of a higher or lower
amperage rating than specified on the
fuse box cover. This could damage the
electrical system or cause a fire.
If any electrical equipment does not come on,
check for an open fuse.
Be sure the ignition switch and the headlight
switch are ...
Symptom diagnosis
Noise, vibration and harshness (NVH) troubleshooting
NVH troubleshooting chart
Locate the area where noise occurs.
Confirm the type of noise.
Specify the operating condition of engine.
Check specified noise source.
If necessary, repair or replace these parts.
Closely relate ...
Forward-facing child restraint installation using the seat belts
WARNING
The three-point seat belt with Automatic Locking Retractor (ALR) must always
be used when installing a child restraint in the Nissan Sentra.
Failure to activate and use the ALR mode will prevent the child restraint
from being properly secured. An unsecured or unstable restraint may tip ...