Dtc Description

DTC Description

The Signal Tech II Tool [– (NI-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information.

• Activate and display TPMS sensor IDs

• Display tire pressure reported by the TPMS sensor

• Read TPMS DTCs

• Register TPMS sensor IDs

DTC DETECTION LOGIC

POSSIBLE CAUSE

• Driving in area with radio interference

• Rear left tire pressure sensor ID registration incomplete

• Rear left tire pressure sensor

• Harness or connectors

• BCM

FAIL-SAFE

—

Dtc Confirmation Procedure

DTC Confirmation Procedure

1. TIRE PRESSURE SENSOR ID REGISTRATION

   1. Perform tire pressure sensor ID registration. Refer to Work Procedure.

   >>

   GO TO 2.

2. PERFORM DTC CONFIRMATION

   1. CONSULT

      1. Drive the Nissan Sentra vehicle at 25 MPH (40 km/h) or more reaches 10 minuets in total.

         Note:

         Avoid driving in areas with radio interference.

      2. Stop the Nissan Sentra vehicle.

      3. Select “Self Diagnostic Result” mode of “BCM(AIR PRESSURE MONITOR)”.

   Is DTC “C1743-21” detected?

   YES>>

   Refer to DTC Diagnosis Procedure.

   NO>>

   To check malfunction symptom before repair: Refer to Intermittent Incident.

   NO>>

   Confirmation after repair: Inspection End.

Dtc Diagnosis Procedure

DTC Diagnosis Procedure

The Signal Tech II Tool [– (NI-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information.

• Activate and display TPMS sensor IDs

• Display tire pressure reported by the TPMS sensor

• Read TPMS DTCs

• Register TPMS sensor IDs

1. CHECK TIRE PRESSURE SIGNAL

   1. CONSULT

      1. Select "AIR PRESS RL" in "Data Monitor" mode of "BCM(AIR PRESSURE MONITOR)".

      2. Check that the rear left tire pressures match the standard value. Refer to Values on the Diagnosis Tool.

         Note:

         BCM holds last tire pressure values during 17 minutes after ignition switch OFF.

   Are all tire pressures displayed 0 kPa (psi)?

   YES >>

   GO TO 2.

   NO >>

   GO TO 3.

2. CHECK BCM POWER SUPPLY CIRCUIT

   1. Check BCM power supply circuit. Refer to Diagnosis Procedure.

   Is the inspection result normal?

   YES >>

   GO TO 3.

   NO >>

   Repair or replace harness or connectors.

3. TIRE PRESSURE SENSOR ID REGISTRATION

   1. Perform tire pressure sensor ID registration. Refer to Work Procedure.

   Can the tire pressure sensor ID registration be completed?

   YES >>

   GO TO 4.

   NO >>

   Replace applicable rear left tire pressure sensor. Refer to Removal and Installation.

4. RECHECK TIRE PRESSURE SIGNAL

   1. CONSULT

      1. Drive the Nissan Sentra vehicle at 25 MPH (40 km/h) or more reaches 10 minuets in total.

         Note:

         Avoid driving in areas with radio interference.

      2. Stop the Nissan Sentra vehicle.

      3. Select "AIR PRESS RL" in "Data Monitor" mode of "BCM(AIR PRESSURE MONITOR)".

      4. Check that the rear left tire pressures match the standard value. Refer to Values on the Diagnosis Tool.

   Is the inspection result normal?

   YES>>

   After erasing DTC record, Inspection End.

   NO>>

   Replace BCM. Refer to Removal and Installation.