Nissan Sentra B18 (2020-2025) Service Manual: B2723 Corner Sensor [rr]
Dtc Description
DTC Description
DTC DETECTION LOGIC
|
DTC No. |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition |
||
|---|---|---|---|---|
|
B2723–60 |
CORNER SENSOR [RR] (Rear sonar sensor RH outer) |
— |
Diagnosis condition |
When ignition switch is ON |
|
Signal (terminal) |
— |
|||
|
Threshold |
Rear sonar sensor RH outer internal failure (reset error) |
|||
|
Diagnosis delay time |
— |
|||
|
B2723–61 |
Diagnosis condition |
When ignition switch is ON |
||
|
Signal (terminal) |
— |
|||
|
Threshold |
Rear sonar sensor RH outer internal failure (configuration error) |
|||
|
Diagnosis delay time |
— |
|||
|
B2723–62 |
Diagnosis condition |
When ignition switch is ON |
||
|
Signal (terminal) |
— |
|||
|
Threshold |
Rear sonar sensor RH outer internal failure (power supply error) |
|||
|
Diagnosis delay time |
— |
|||
|
B2723–63 |
Diagnosis condition |
When ignition switch is ON |
||
|
Signal (terminal) |
— |
|||
|
Threshold |
Rear sonar sensor RH outer internal failure (self diag result) |
|||
|
Diagnosis delay time |
— |
|||
|
B2723–65 |
Diagnosis condition |
When ignition switch is ON |
||
|
Signal (terminal) |
— |
|||
|
Threshold |
Rear sonar sensor RH outer internal failure (over temperature) |
|||
|
Diagnosis delay time |
— |
|||
|
B2723–66 |
Diagnosis condition |
When ignition switch is ON |
||
|
Signal (terminal) |
Rear outer right sensor signal (terminal 10) |
|||
|
Threshold |
Rear outer right sensor signal circuit is open or short to ground |
|||
|
Diagnosis delay time |
— |
|||
|
B2723–67 |
Diagnosis condition |
When ignition switch is ON |
||
|
Signal (terminal) |
— |
|||
|
Threshold |
Rear sonar sensor RH outer internal failure (diag dump error) |
|||
|
Diagnosis delay time |
— |
|||
|
B2723–68 |
Diagnosis condition |
When ignition switch is ON |
||
|
Signal (terminal) |
— |
|||
|
Threshold |
Rear sonar sensor RH outer internal failure (resonator error) |
|||
|
Diagnosis delay time |
— |
|||
|
B2723–83 |
Diagnosis condition |
When ignition switch is ON |
||
|
Signal (terminal) |
— |
|||
|
Threshold |
Rear sonar sensor RH outer internal failure (CRC error) |
|||
|
Diagnosis delay time |
— |
|||
|
B2723–92 |
Diagnosis condition |
When ignition switch is ON |
||
|
Signal (terminal) |
— |
|||
|
Threshold |
Rear sonar sensor RH outer internal failure (membrane error) |
|||
|
Diagnosis delay time |
— |
|||
POSSIBLE CAUSE
-
Harness or connectors
-
Rear sonar sensor RH outer
FAIL-SAFE
-
Obstacle detection of rear sonar sensor RH outer is stopped
-
Audible warning (sonar buzzer) of all sensors is stopped
-
Sonar buzzer sounds for 3 seconds
Dtc Confirmation Procedure
DTC Confirmation Procedure
-
DTC CONFIRMATION PROCEDURE
-
CONSULT-
Ignition switch ON.
-
Ignition switch OFF and wait at least 30 seconds.
-
Ignition switch ON and wait at least 2 seconds or more.
-
Select “Self Diagnostic Result” mode of “SONAR”.
-
Is DTC B2723 detected?
YES>>Refer to DTC Diagnosis Procedure.
NO>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>Confirmation after repair: Inspection End.
-
Dtc Diagnosis Procedure
DTC Diagnosis Procedure
-
DETERMINE MALFUNCTION TYPE
-
CONSULT-
Ignition switch ON.
-
Select “Self Diagnostic Result” mode of “SONAR”.
-
Check DTC.
-
Is DTC B2723–60, 61, 62, 63, 65, 66, 67, 68, 83 or 92 detected?
YES >>66 – GO TO 2.
YES >>60, 61, 62, 63, 65, 67, 68, 83 or 92 – GO TO 5.
NO >>Refer to Intermittent Incident.
-
-
CHECK REAR SONAR SENSOR RH OUTER SIGNAL CIRCUIT FOR OPEN OR SHORT TO GROUND
-
-
Ignition switch OFF.
-
Disconnect sonar control unit and rear sonar sensor RH outer connectors.
-
Check continuity between sonar control unit connector and rear sonar sensor RH outer connector.
Sonar control unit
Rear sonar sensor RH outer
Continuity
Connector
Terminal
Connector
Terminal
B87
10
B401
2
Yes
-
Check continuity between sonar control unit connector and ground.
Sonar control unit
—
Continuity
Connector
Terminal
B87
10
Ground
No
-
Is the inspection result normal?
YES >>GO TO 3.
NO >>Repair or replace harness or connectors.
-
-
CHECK REAR SONAR SENSOR RH OUTER GROUND CIRCUIT FOR OPEN
-
-
Ignition switch OFF.
-
Check continuity between sonar control unit connector and rear sonar sensor RH outer connector.
Sonar control unit
Rear sonar sensor RH outer
Continuity
Connector
Terminal
Connector
Terminal
B87
14
B401
1
Yes
-
Is the inspection result normal?
YES >>GO TO 4.
NO >>Repair or replace harness or connectors.
-
-
CHECK REAR SONAR SENSOR RH OUTER SIGNAL
-
-
Connect sonar control unit and rear sonar sensor RH outer connectors.
-
Ignition switch ON.
-
Check signal between the terminals of sonar control unit connector.
Sonar control unit
Condition
Reference value
Connector
(+)
(–)
Terminal
Terminal
B87
10
14
Sensor signal input

-
Is the inspection result normal?
YES >>Replace sonar control unit. Refer to Removal and Installation.
NO >>Replace rear sonar sensor RH outer. Refer to Removal and Installation.
-
-
PERFORM DTC CONFIRMATION PROCEDURE AGAIN
-
CONSULT-
Ignition switch ON.
-
Erase DTC.
-
Select “Self Diagnostic Result” mode of “SONAR”.
-
Check DTC.
-
Is DTC B2723–60, 61, 62, 63, 65, 67, 68, 83, or 92 detected?
YES >>Replace rear sonar sensor RH outer. Refer to Removal and Installation.
NO >>Inspection End.
-
Other materials:
Component Parts
Rear Automatic Braking System
Component Parts Location
Component Parts Location
A.
Right side of instrument panel
(view with glove box assembly
removed)
...
Back-Up Lamp Relay Circuit
Component Function Check
Component Function
Check
CHECK BACK-UP LAMP OPERATION
Ignition switch ON.
With operating the shift selector, check that the
back-up lamp is turn ...
Symptom Diagnosis
The Fuel Gauge Indicator Does Not Operate
Description
Description
Fuel gauge will not indicate from a certain
position.
Diagnosis Procedure
Diagnosis Procedure
PERFORM COMBINATION METER
SELF-DIAGNOSIS MODE
Perform the self-diagnosis mode ...