Dtc Description
DTC DETECTION LOGIC
|
DTC No. |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition |
||
|---|---|---|---|---|
|
B1305–04 |
Control unit internal error (AV control unit internal fault) |
[—] |
Diagnosis condition |
When ignition switch is ON. |
|
Signal (terminal) |
– |
|||
|
Threshold |
Internal fault |
|||
|
Diagnosis delay time |
30 seconds or more |
|||
POSSIBLE CAUSE
AV control unit internal fault
FAIL-SAFE
AV control unit internal error
Confirmation Procedure
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
Ignition switch ON.
Ignition switch OFF and wait at least 30 seconds.
Ignition switch ON and wait at least 30 seconds or more.
Select “Self Diagnostic Result” mode of “MULTI AV”.
Check DTC.
Is DTC B1305–04 detected?
YES >>Proceed to DTC Diagnosis Procedure.
NO >>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO >>Confirmation after repair: Inspection End.
Dtc Diagnosis Procedure
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
Ignition switch ON.
Ignition switch OFF and wait at least 30 seconds.
Ignition switch ON and wait at least 30 seconds or more.
Select “Self Diagnostic Result” mode of “MULTI AV”.
Check DTC.
Is DTC B1305–04 detected?
YES >>Replace AV control unit. Refer to Removal and Installation.
NO >>Inspection End.
B130b Rear Rh SpeakerControl panel buttons — color screen with Navigation System (if so equipped)
WARNING
Positioning of the heating or air conditioning
controls and display controls
should not be done while driving in order
that full attention may be given to
the driving operation.
Do not disassemble or modify this system.
If you do, it may result in acciden ...
P0223 Tp Sensor
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis
content)
DTC detection
condition
...
Precaution for work
When removing or disassembling each component, be careful not to damage
or deform it. If a component
may be subject to interference, be sure to protect it with a shop cloth.
When removing (disengaging) components with a screwdriver or similar
tool, be sure to wrap the component
with a ...