Nissan Sentra manuals

Nissan Sentra Service Manual: Wiring diagram

Consult checking system

Wiring Diagram

Engine


CONSULT Data Link Connector (DLC) Circuit
Inspection procedure If the CONSULT cannot diagnose the system properly, check the following items. Symptom Check item CONSULT cannot access any system. CONSULT D ...

Engine
...

Other materials:

Removal and installation
SIDE OIL SEAL Removal and Installation REMOVAL Remove front drive shafts. Refer to FAX-18, "6M/T : Removal and Installation (LH)". Remove differential side oil seals (1) from clutch housing and transaxle case using a suitable tool. CAUTION: Do not damage transaxle case an ...

DTC/circuit diagnosis
U1000 can comm Description Refer to LAN-7, "CAN COMMUNICATION SYSTEM : System Description". Dtc logic DTC DETECTION LOGIC NOTE: U1000 can be set if a module harness was disconnected and reconnected, perhaps during a repair. Confirm that there are actual CAN diagnostic symptoms a ...

Engine block heater (if so equipped)
Engine block heaters are used to assist with cold temperature starting. The engine block heater should be used when the outside temperature is 20°F (-7°C) or lower. WARNING Do not use your engine block heater with an ungrounded electrical system or a 2-pronged adapter. You ...

© 2014-2025 Copyright www.nisentra.com