Nissan Sentra Service Manual: Wiring diagram

Power generation voltage variable control system

System Diagram System Description Power generation variable voltage control system has been adopted. By varying the voltage to the generator, engine load due to power generation of the gener ...

Basic inspection

Diagnosis and repair workflow Work flow (with exp-800 ni or gr8-1200 ni) CHARGING SYSTEM DIAGNOSIS WITH EXP-800 NI OR GR8-1200 NI To test the charging system, use the following special service tool ...

Other materials:

Removal and installation
BCM Removal and installation Note: Before replacing BCM, perform “READ CONFIGURATION” to save or print current vehicle specification. Refer to BCS-61, "CONFIGURATION (BCM) : Description". Removal Disconnect the negative battery terminal. Refer to pg-52, "removal a ...

Symptom diagnosis
Squeak and rattle trouble diagnoses Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the facts and conditions when the noise occurs and any custom ...

Passenger compartment
CAUTION Never use a fuse of a higher or lower amperage rating than specified on the fuse box cover. This could damage the electrical system or cause a fire. If any electrical equipment does not operate, check for an open fuse. NOTE: The fuse box is located on the driver’s side of the ...