Nissan Sentra Service Manual: The illumination control switch is inoperative
Description
If any of the following malfunctions is found for the illumination control switch operation.
- All switches are inopera
- The specified switch cannot be operated
Diagnosis procedure
1.Check illumination control switch signal circuit
Check the illumination control switch signal circuit. Refer to mwi-56, "diagnosis procedure".
Is the inspection result normal? Yes >> go to 2.
No >> repair or replace harness or connector.
2.Check illumination control switch
Check the illumination control switch. Refer to mwi-56, "component inspection".
Is the inspection result normal? Yes >> replace combination meter. Refer to mwi-77, "removal and installation".
Ng >> replace illumination control switch. Refer to mwi-80, "removal and installation".
The steering switch (meter control switch) is inoperative
Description
If any of the following malfunctions is found for the steering switch (meter
control switch) operation.
All switches are inoperative
The specified switch cannot be operated
Di ...
The oil pressure warning lamp does not turn on
Description
The oil pressure warning lamp stays off when the ignition switch is turned
on.
Diagnosis procedure
1.Check combination meter oil pressure warning light
Select METER/M&A on CON ...
Other materials:
Front suspension assembly
Inspection
COMPONENT PART
Check the mounting conditions (looseness, backlash) of each component. Verify
the component conditions
(wear, damage) are normal.
Ball Joint Axial End Play
Set the front wheels in a straight-ahead position.
Hold the axle side of the transverse link, and check th ...
Service data and specifications (SDS)
Idle speed
*: Under the following conditions
A/C switch: OFF
Electric load: OFF (Lights, heater fan & rear window defogger)
Steering wheel: Kept in straight-ahead position
Ignition timing
*: Under the following conditions
A/C switch: OFF
Electric load: OFF (Lights, hea ...
Connecting Procedure
NOTE:
The connecting procedure must be performed
when the vehicle is stationary. If the
vehicle starts moving during the procedure,
the procedure will be cancelled.
Press the [ ] button on the
control
panel.
Touch the “Settings” key.
Touch the “Phone & Bluetooth” ke ...
